Drum Heater for Metal 55 Gallon Drums 120 V

Write a Review
Calculated at Checkout
Adding to cart… The item has been added

ELECTRIC DRUM HEATER With Pre-Set Thermostat For 55 Gallon Steel Drums

Use a safe and efficient drum heater to increase flow rate of viscous materials.

Our model TRX-55 120V heater is an excelent choice for warming and heating steel drums. This drum heater features a thermostat and three heat switch

The WRAP-IT-HEAT® Model TRX-55 Drum Heater, is a thermostatically controlled drum
heater  with a three heat switch. Model TRX-55 Drum Heater is for standard 55 gallon all
METAL drums.  The TRX-55 is designed for heating liquid products that can be heated safely and have good heat receptivity.

When ordering choose one of two thermostat ranges: LOW 60 F, to 250 F or  High, 200°F - 400°F. The heat switch has  three wattage ratings per thermostat setting and voltage rating:LOW = 1/4" Maximum Watts.  MEDIUM = 1/2" and HIGH = Maximum Watts. Choose the thermostat range when ordering. 

Equipped with a spring loaded toggle clamp for snug fit,and 6 foot
power cord and high ampere three pin plug.  For 120V operation, use NEMA 5-20 Outlet.  

We also offer this model for use with the 240V operation, using a NEMA 6-15 Outlet.


Operating Voltage........120V AC Single Phase
Power Output...............1,920W @ 120V            
Thermostat Range............60°F to 250°F or 200°F to 400°F         
Amperage ...................16 A at 120 V

6' Cord with NEMA 5-20 plug

CSA Certified, UL Listed

Warranted for one year.


Only for indoor use. Units are not moisture-proof nor explosion-proof. Not for use with flammables or near a flammable area.

Caution: Do not warm or heat drums unattended and without monitoring. Do not allow liquid in a container to fall below the level of the heater will render the heater ineffective and could irreparably damage the plastic drum and potentially cause injury or damage or be a fire hazard. 

Electric drum heaters should only be used to warm or to heat NON-FLAMMABLE, NON-COMBUSTIBLE materials only in a NON-HAZARDOUS area.

Read all directions and insturctions thoroughly before using. 

Consult an electrician to make sure your connections and outlets are safe and suitable for this product before use.