ELECTRIC DRUM HEATER With Pre-Set Thermostat - For 55 Gallon Steel Drums
Drum Heater 240 V
Increase the flow rate of viscous materials with a safe, efficient Electric Drum Heater.
Our model TRX-55 240V heater is an excellent choice for warming and heating viscous materials in steel drums.
55 gal. drum heater with thermostat and a three heat switch
The WRAP-IT-HEAT® Model TRX-55 Drum Heater, 240 V is a thermostatically controlled drum
heater with a three heat switch. Model TRX-55 Drum Heater is for standard 55 gallon all
METAL drums. The TRX-55 240 V is especially designed for heating viscous liquid products that can be heated safely and have good heat receptivity.
The user can choose one of the two thermostat ranges: LOW 60 F, to 250 F or High, 200°F - 400°F. The heat switch has three wattage ratings per thermostat setting and voltage rating: LOW = 1/4" Maximum Watts. MEDIUM = 1/2" Maximum Watts HIGH = Maximum Watts.
Equipped with a spring loaded toggle clamp for snug fit,and 6 foot
power cord and high ampere three pin plug. For 240V operation, use NEMA 6-15 Outlet
We also offer this model for use with the 120V drum heater, using a NEMA 5-20 Outlet.
SPECS:
Operating Voltage........240V AC Single Phase
Power Output...............3,000W @ 240V
Thermostat Range............60°F to 250°F or 200°F to 400°F
Amperage ...................12.5 @ 240 V Plug
6' Cord with NEMA 5-20 plug
CSA Certified, UL Listed
Warranted for one year.
WARNINGS
Only for indoor use. Units are not moisture-proof nor explosion-proof. Not for use with flammables or near a flammable area.
Caution: Do not warm or heat drums unattended and without monitoring. Do not allow liquid in a container to fall below the level of the heater will render the heater ineffective and could irreparably damage the plastic drum and potentially cause injury or damage or be a fire hazard.
Electric drum heaters should only be used to warm or to heat NON-FLAMMABLE, NON-COMBUSTIBLE materials only in a NON-HAZARDOUS area.
Read all instructions thoroughly before using.
Consult an electrician to make sure your connections and outlets are safe and suitable for this product before use.
